It turns out that I did not have any definition file for init for this
vserver. Is that normal?
I made it plain init and this service ( watchdog which monitors and
restarts dead services ) in plesk worked fine.
But now when I reboot inside the guest, it just shuts it down and does
not restart it.
-----Original Message-----
From: Herbert Poetzl [mailto:herbert@13thfloor.at]
Sent: Friday, April 21, 2006 7:33 PM
To: ehab heikal
Cc: vserver@list.linux-vserver.org
Subject: Re: [Vserver] Application problem, signal to init failed?
On Fri, Apr 21, 2006 at 02:27:47PM +0200, ehab heikal wrote:
>
> I installed plesk 8 on a vserver and it is working ok till now. One
> issue I have is that its watchdog which watches if services are up and
> tries to automatically restart them is not working. It gives the
> following error when I try to enable it.
>
> Error occurred while calling the module utility wdservice: 'Send
> signal to init failed'
are you sure that your guest has an init running
and not such a fake-init blendthrough?
(check the init stlye, sysv means fake, plain means real)
HTH,
Herbert
> Seems like a capabilities problem. Does anyone have a clue which
> Capability might cause a signal to init to fail?
>
> I have the following caps enabled.
> CAP_NET_BIND_SERVICE
> CAP_NET_BROADCAST
> CAP_NET_ADMIN
> CAP_NET_RAW
> CAP_SYS_ADMIN
> CAP_SYS_RESOURCE
> CAP_SYS_TIME
> CAP_SETPCAP
> CAP_LINUX_IMMUTABLE
>
> _______________________________________________
> Vserver mailing list
> Vserver@list.linux-vserver.org
> http://list.linux-vserver.org/mailman/listinfo/vserver
_______________________________________________
Vserver mailing list
Vserver@list.linux-vserver.org
http://list.linux-vserver.org/mailman/listinfo/vserver
Received on Sun Apr 23 17:08:14 2006