About this list Date view Thread view Subject view Author view Attachment view

From: Holger.Manthey_at_Bertelsmann.de
Date: Fri 21 Jan 2005 - 12:50:17 GMT


Hi,

i have a strange behavior of Kernel 2.6.10-vs1.9.3.17 on SuSE 9.2. The
kernel uses the wrong route/interface (see below). If i reboot the
system with original suse kernel or unpatched vanilla 2.6.10 with same
configuration, the outgoing request uses the right interface eth1.

This is not inside a vserver, the only change i did was applying the
vserver-patch and enabling CONFIG_VSERVER_HARDCPU=y, there are no
further iptable or policy routing defines.

thanks in advance
Holger Manthey

My configuration:

The 2 network devices
eth0 inet addr:x.y.z.10 Bcast:x.y.z.127 Mask:255.255.255.128
eth1 inet addr:172.25.128.10 Bcast:172.25.128.127
Mask:255.255.255.128

and this is my routing table
Destination Gateway Genmask Flags MSS Window irtt
Iface
172.23.152.0 172.25.128.1 255.255.255.192 UG 0 0 0
eth1
172.25.128.0 0.0.0.0 255.255.255.128 U 0 0 0
eth1
x.y.z.0 0.0.0.0 255.255.255.128 U 0 0 0
eth0
169.254.0.0 0.0.0.0 255.255.0.0 U 0 0 0
eth0
127.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0
lo
0.0.0.0 x.y.z.1 0.0.0.0 UG 0 0 0
eth0

ping 172.25.128.1
PING 172.25.128.1 (172.25.128.1) 56(84) bytes of data.
>From x.y.z.10: icmp_seq=2 Destination Host Unreachable
_______________________________________________
Vserver mailing list
Vserver_at_list.linux-vserver.org
http://list.linux-vserver.org/mailman/listinfo/vserver


About this list Date view Thread view Subject view Author view Attachment view
[Next/Previous Months] [Main vserver Project Homepage] [Howto Subscribe/Unsubscribe] [Paul Sladen's vserver stuff]
Generated on Fri 21 Jan 2005 - 13:20:58 GMT by hypermail 2.1.3