RE: [vserver] upgrade VServer breaks lsusb

From: John A. Wallace <jw72253_at_hotmail.com>
Date: Sat 11 Oct 2014 - 18:01:17 BST
Message-ID: <BLU436-SMTP1952BE7D15E90851D6E9D25E3AE0@phx.gbl>

I want to add one more point about this problem. When I try to use lsusb, as
mentioned below, I get an error message like so:

 

"unable to initialize libusb: -99".

 

Still, searching for this expression with Google led to no positive result
in this particular case insofar as I was able to know.

 

 

From: John A. Wallace [mailto:jw72253@hotmail.com]
Sent: Friday, October 10, 2014 10:46 PM
To: vserver@list.linux-vserver.org
Subject: [vserver] upgrade VServer breaks lsusb

 

When I install Gentoo Linux-3.13.11-vserver-2.3.6.11 using the very same
kernel ".config" file used for linux-3.10.4-vserver-2.3.6.8, I can no longer
use lsusb, although it, lsusb, works just fine on the earlier one. I have
scratched my head bare trying to figure out what the problem is, but
trial-and-error and google have gotten me no closer to a solution. I am not
a developer, but I have found that with VServer-2.3.6.8 there is a
"/dev/bus/usb" getting created; but with VServer-2.3.6.11 there is no
"/dev/bus" created.

I am pretty much at a loss as to how I can troubleshoot this, but I am
willing to try up to a point, depending on time constraints. If someone has
any suggestions, I would sure like to hear them. Thanks.
Received on Sat Oct 11 18:01:29 2014

[Next/Previous Months] [Main vserver Project Homepage] [Howto Subscribe/Unsubscribe] [Paul Sladen's vserver stuff]
Generated on Sat 11 Oct 2014 - 18:01:29 BST by hypermail 2.1.8