Re: [vserver] Apache unable to bind

From: Tomasz Pajor <>
Date: Mon 23 Apr 2012 - 10:30:42 BST
Message-Id: <>


Can you double check that you don't have anything bind on the main interface to port 80?

Best regards
Tomasz Pajor
On Apr 23, 2012, at 10:17 AM, Phil Daws wrote:
> Hello all,
> I moved a guest between servers over the weekend and when I attempted to start it I received the following error:
> Starting httpd: (98)Address already in use: make_sock: could not bind to address
> I checked its etc/hosts and that did not have the loopback address in it. I even tried binding the IP address on Listen in httpd.conf.
> There are two other guests on the server that run an Apache instance and NGINX as-well. I shut both of them down and then the moved guest could happily start Apache. If I shut everything down and started the NGINX guest first followed by the existing Apache instance both work fine.
> Any thoughts as to why this moved guest cannot start Apache ? It is though something is completely glomming port 80 :(
> -- 
> Thanks, Phil
Received on Mon Apr 23 10:30:54 2012
[Next/Previous Months] [Main vserver Project Homepage] [Howto Subscribe/Unsubscribe] [Paul Sladen's vserver stuff]
Generated on Mon 23 Apr 2012 - 10:30:54 BST by hypermail 2.1.8