[vserver] Network access problem!

From: songxuefei 47810 <songxuefei_at_huawei.com>
Date: Thu 16 Jul 2009 - 05:15:36 BST
Message-id: <fae8928c1b677.1b677fae8928c@huawei.com>

Hello all,

I build a vserver and give the interface configuration, but the vserver can't connect to the host. The ping command doesn't work properly. I use the packet capture tools. It seems that the vserver can't receive the reply messages. The detail interface configuration information is below:

Interface configuration:

echo "eth4" > /etc/vservers/xxx./interfaces/0/dev
echo "" > /etc/vservers/xxx/interfaces/0/ip
echo "24" > /etc/vservers/xxx/interfaces/0/mask

The ip address of host os is "".

and then I start the vserver xxx, enter the vserver xxx, try to ping the ip address "", and the result is below:

bash-3.2# ping
PING ( ) 56(84) bytes of data.

--- ping statistics---
6 packets transmitted, 0 received, 100% packet loss, time 5007ms

I use the packet capture tools, the ping request and reply appeard both, it is so strange, the result is below:

No. Time Source Destination Protocol Info
1 0.000000 ICMP request
2 0.000023 ICMP reply
3 1.008884 ICMP request
4 1.008902 ICMP reply
5 2.008589 ICMP request
6 2.008609 ICMP reply
7 3.008266 ICMP request
8 3.008283 ICMP reply
9 4.007962 ICMP request
10 4.007983 ICMP reply

 This email and its attachments contain confidential information from HUAWEI, which is intended only for the person or entity whose address is listed above. Any use of the information contained here in any way (including, but not limited to, total or partial disclosure, reproduction, or dissemination) by persons other than the intended recipient(s) is prohibited. If you receive this email in error, please notify the sender by phone or email
 immediately and delete it!
Received on Thu Jul 16 05:19:37 2009

[Next/Previous Months] [Main vserver Project Homepage] [Howto Subscribe/Unsubscribe] [Paul Sladen's vserver stuff]
Generated on Thu 16 Jul 2009 - 05:19:40 BST by hypermail 2.1.8