Hi,
I try to configure a server with 2 physical interfaces (eth0
and eth1).
The host uses eth0 with IP 172.20.128.110.
I created a vserver named vs03. It uses eth1 with IP
194.57.88.253.
On my host (debian sarge), I configure my network with :
# The loopback network interface
auto lo
iface lo inet loopback
# The primary network interface
auto eth0
iface eth0 inet static
address 172.20.128.110
netmask 255.255.255.0
network 172.20.128.0
broadcast 172.20.128.255
gateway 172.20.128.254
up ip route add 172.20.128.0/24 dev eth0 src 172.20.128.110
table 64
up ip route add default via 172.20.128.254 table 64
up ip rule add from 172.20.128.0/24 table 64
post-down ip rule delete from 172.20.128.0/24 table 64
auto eth1
iface eth1 inet static
address 194.57.88.253
netmask 255.255.255.0
network 194.57.88.0
broadcast 194.57.88.255
up ip route add 194.57.88.0/24 dev eth1 src 194.57.88.253
table 68
up ip route add default via 194.57.88.254 table 68
up ip rule add from 194.57.88.0/24 table 68
post-down ip rule delete from 194.57.88.0/24 table 68
When I disconnect eth1, I can ping 172.20.128.110. Why ? Where
I make a mistake ?
Thank.
Jean-Michel Caricand
jean-michel.caricand@laposte.net
Accédez au courrier électronique de La Poste : www.laposte.net ;
3615 LAPOSTENET (0,34 €/mn) ; tél : 08 92 68 13 50 (0,34€/mn)
_______________________________________________
Vserver mailing list
Vserver@list.linux-vserver.org
http://list.linux-vserver.org/mailman/listinfo/vserver
Received on Thu May 18 14:59:52 2006