From: Gaz Wilson (dragon_at_dragons.org.uk)
Date: Thu 31 Mar 2005 - 17:56:22 BST
On Thu, 31 Mar 2005, Gilles wrote:
> > > test01:/# ifconfig
> > > Segmentation fault
> > > test01:/# ifconfig -a
> > > Segmentation fault
> >
> > Forbidden (network hardware) inside the vserver.
>
> Sorry, this should work (as long as you don't want to set up the
> interface...).
Hehe - I was just about to write a reply about your previous reply, Gilles!
Yes, I simply want to use ifconfig to show the interface, not configure
it. Interestingly enough, the IP _IS_ configured as I can ping it from
within the vserver - yet ifconfig refuses to work for as yet unknown
reasons.
In a previous incarnation, I tested with Debian under 2.4 kernel and the
packaged vserver software, and I do recall it worked there, showing a
virtual interface as well as the main eth0 of the host. Unfortunately
I need the more rich featureset offered in the 2.6/devel vserver setup,
which is why I'm struggling :(
-- / Gary Wilson, aka dragon/dragonlord/dragonv480 \ .'(_.------. e: dragon_at_northernscum.org.uk MSN: dragonv480 .------._)`. < _ | Skype:dragonv480 ICQ:342070475 AIM:dragonv480 | _ > `.( `------' w: http://volvo480.northernscum.org.uk `------' ).' \ w: http://www.northernscum.org.uk / _______________________________________________ Vserver mailing list Vserver_at_list.linux-vserver.org http://list.linux-vserver.org/mailman/listinfo/vserver