From: Thomas Gelf (vserver_at_gelf.net)
Date: Wed 18 Aug 2004 - 07:22:43 BST
hmmm... just for fun yesterday we tested squid (from debian sarge) in
a vserver - squid was running "out-of-the-box", even with squidguard
there was no problem. we are using kernel 2.6.7 with vs1.9.2-rc10 and
we didn't grant any extra privilege to this vserver.
inside a vserver you can bind to 0.0.0.0 without any problem, you
should only care about ip addresses at the host side. if your vserver
is configured right and already running other (working) services and
your host doesn't use ports needed by squid in your vserver your
problem is probably squid-related - no error in the logs?
cheers
thomas
Am Mi, den 18.08.2004 schrieb jfl um 2:53:
> Hello again,
>
> Thanks to Christian Mayrhuber I am running bind in a vserver... but now
> I am having trouble with squid.
>
> Squid runs, but does not accept connections.
>
> I thought that I had read that vservers strove with their hosts if
> configured to list at IP address 0.0.0.0, so I changed what seemed to be
> the relevant 0.0.0.0 addresses in squid.conf to the squid's vserver IP
> address, but I still cannot connect to the squid using either a
> requesting browser or via telnet.
>
> I haven't found any reference to squid in the FAQs or in the last year's
> archives.
>
> Any help would be appreciated.
>
> Thanks.
>
> _______________________________________________
> Vserver mailing list
> Vserver_at_list.linux-vserver.org
> http://list.linux-vserver.org/mailman/listinfo/vserver
-- Thomas Gelf <vserver_at_gelf.net>_______________________________________________ Vserver mailing list Vserver_at_list.linux-vserver.org http://list.linux-vserver.org/mailman/listinfo/vserver