From: Mike Savage (Mike.Savage_at_datastream.net)
Date: Mon 09 Jun 2003 - 14:33:04 BST
The RedHat-supplied kernel employs the Intel version of the driver, e100.0,
for your NIC. The vanilla kernel, which the vserver is most like as no
modules/drivers patches are applied against it AFAIK, supplies the original
open source driver, eepro100.o, by Donald Becker.
So, change this line...
alias eth0 e100
To this...
alias eth0 eepro100
...in /etc/modules.conf if you are always going to boot into your vserver
kernel.
Dual booting between the stock RedHat kernel and the vserver kernel would
require some additional finesse in order to get your NIC to work without
intervention at boot time.
Hope that helps,
Mike
-----Original Message-----
From: Joseph S Chung [mailto:jschung_at_itsd.gov.hk]
Sent: Friday, June 06, 2003 10:21 PM
To: vserver_at_solucorp.qc.ca
Subject: RE: Re[2]: [vserver] eth0 fail to start
Please find /etc/modules.conf below...
==============================================
alias eth0 e100
alias usb-controller usb-uhci
alias sound-slot-0 es1370
post-install sound-slot-0 /bin/aumix-minimal -f /etc/.aumixrc -L
>/dev/null 2>&1 || :
pre-remove sound-slot-0 /bin/aumix-minimal -f /etc/.aumixrc -S >/dev/null
2>&1 || :
==============================================
Thanks,
Joseph
From: Mike Savage <Mike.Savage_at_datastream.net> on 06/06/2003 21:40 Please
respond to vserver_at_solucorp.qc.ca
To: "'vserver_at_solucorp.qc.ca'" <vserver_at_solucorp.qc.ca>
cc:
Subject: RE: Re[2]: [vserver] eth0 fail to start
What does the contents of your /etc/modules.conf file look like?
-----Original Message-----
From: Joseph S Chung [mailto:jschung_at_itsd.gov.hk]
Sent: Thursday, June 05, 2003 11:03 PM
To: vserver_at_solucorp.qc.ca
Subject: Re[2]: [vserver] eth0 fail to start
I do not see eth0 with ifconfig command. It is not working.
I did not complie the kernel after downloading from web. How can I get the
.config file. I do not have one in /usr/src/linux-2.4. By the way, I am
using RedHat 9.0. Thanks. Joseph
From: Guillaume Plessis <gui_at_moolfreet.com> on 05/06/2003 18:07 Please
respond to vserver_at_solucorp.qc.ca
To: vserver_at_solucorp.qc.ca
cc:
Subject: Re: [vserver] eth0 fail to start
Joseph S Chung wrote:
> I am not sure. It is Intel 82557/8/9 Ethernet Pro 100. How can I
> check? Thanks, Joseph
There are many way do to this :
1/ Check that the following options are marked "=y" or "=m" in the .config
file used during your kernel compilation: CONFIG_NET_PCI CONFIG_EEPRO100 in
case of "=m", you ahve to check that the modules is loaded during the system
boot
2/ check that you get eth0 when you lauch "ifconfig -a"
3/ ...
Best regards
Gui