About this list Date view Thread view Subject view Author view Attachment view

From: Roderick A. Anderson (raanders_at_tincan.org)
Date: Wed 13 Feb 2002 - 14:20:48 GMT


On Wed, 13 Feb 2002, Martin Josefsson wrote:

> Hi,
>
> I noticed that it's possible to see all ipaddresses on all interfaces in
> an vserver when it should only be possible to see the ipv4root address.

Seems to me the lastest kernel and package make this so.

Here is the results of ifconfig in a virtaul server

eth0 Link encap:Ethernet HWaddr 00:80:AD:71:22:2C
          UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
          RX packets:701060 errors:0 dropped:0 overruns:0 frame:0
          TX packets:48393 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:100
          RX bytes:76531350 (72.9 Mb) TX bytes:7184647 (6.8 Mb)
          Interrupt:11 Base address:0xe800

eth0:vs1 Link encap:Ethernet HWaddr 00:80:AD:71:22:2C
          inet addr:216.64.180.227 Bcast:216.64.180.255 Mask:255.255.255.255
          UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
          Interrupt:11 Base address:0xe800

lo Link encap:Local Loopback
          UP LOOPBACK RUNNING MTU:16436 Metric:1
          RX packets:877 errors:0 dropped:0 overruns:0 frame:0
          TX packets:877 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:75810 (74.0 Kb) TX bytes:75810 (74.0 Kb)

> ifconfig works as it should but ip from the iproute2 package uses netlink
> IIRC and there I can see all addresses of all interfaces.

OOPS! Is the above relavant?

Regards,
Rod

-- 
                      Let Accuracy Triumph Over Victory

Zetetic Institute "David's Sling" Marc Stiegler


About this list Date view Thread view Subject view Author view Attachment view
[Next/Previous Months] [Main vserver Project Homepage] [Howto Subscribe/Unsubscribe] [Paul Sladen's vserver stuff]
Generated on Wed 06 Nov 2002 - 07:03:39 GMT by hypermail 2.1.3